My 2014 never had the front bracket installed or the holes drilled into the front bumper.:banana: However, after getting pulled over and receiving a written warning I thought I better install it. Front Plate Bracket Honda Odyssey Zip Ties Which.Front Plate Bracket Honda Odyssey Free Car Wash.ft)ġ0. Insert the new shift cable through the grommet.NOTE: To prevent damage to the control lever joint, remove the bolts securing the shift cable holder before removing the bolts securing the shift cable cover.ĩ. Remove the lock bolt (C) securing the control lever Then separate the shift cable (C) from the shift lever assembly (D).Ħ. Rotate the socket holder (E) on the shift cableĬounterclockwise a quarter turn, then slide the holder to remove the shift cable from the shift cable bracket (F).ħ. Remove the shift cable guide bracket (A) andĨ. Remove the bolts securing the shift cable holder (A), SRS components are located in this area. Review the SRS component locations (see page 23-18), and the precautions and procedures (see page 23-21) in the SRS before performing repairs or service.ġ. Raise the front of the vehicle, and make sure it isĢ. Set the parking brake, and block the rear wheelsģ. Remove the steering column covers (see page 17-Ĥ. Shift the transmission into the N position.ĥ. when i purchased my 2001 accord, there was a license plate bracket placed in the trunk - to attach to the front, under the bumper. Hole, then install the shift cable guide bracket.ġ1. Verify that the transmission is in the N position onġ2. Install the control lever (A) with the shift cable (B) This will likely cause more unsightly damage than the factory bracket mounted in the proper location would. I was thinking of installing the front license plate on my wife's 08 EXL. since I live in a state w/no front plate, i just kept it just in case i ever moved to one requiring a front plate. I see where the two bottom screws go, but it looks like the top screw goes into the bumper. when i traded in my accord, i was polite enough to put the bracket. On the control shaft (C). Do not bend the shift cable excessively.ġ3. Install the lock bolt (D) with a new lock washer (E), If the vehicle will always have a front plate on, I don't see the point of this.Īny time you 'rest' something against the paint, expect damage. Then bend the lock washer tab against the bolt head.ġ4. Install the shift cable cover (F), then install the shiftĬable holder (G) on the shift cable cover.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |